ZyXEL Communications 5 Series - Manual (Page 145)

ZyWALL 5/35/70 Series User’s Guide
Chapter 7 Bridge Screens 145
7.4 Bridge Port Roles
Use the Port Roles screen to set ports as part of the LAN, DMZ and/or WLAN interface.
Ports 1~4 on the ZyWALL 5 and ZyWALL 35 ports can be part of the LAN, DMZ or WLAN
interface. The ZyWALL 70 has a separate (dedicated) LAN port, so ports 1~4 can be set as
part of the DMZ and/or WLAN interface.
To change your ZyWALL’s port role settings, click NETWORK > BRIDGE > Port Roles.
The screen appears as shown.
The radio buttons correspond to Ethernet ports on the front panel of the ZyWALL. On the
ZyWALL 70, ports 1 to 4 are all DMZ ports by default. On the ZyWALL 5 or ZyWALL 35,
ports 1 to 4 are all LAN ports by default.
Rapid Spanning Tree
Protocol Setup
Enable Rapid Spanning
Tree Protocol Select the check box to activate RSTP on the ZyWALL.
Bridge Priority Enter a number between 0 and 61440 as bridge priority of the ZyWALL.
Bridge priority is used in determining the root switch, root port and
designated port. The switch with the highest priority (lowest numeric value)
becomes the root. If multiple devices have the lowest priority, the device
with the lowest MAC address becomes the root.
The lower the numeric value you assign, the higher the priority for this
bridge.
Bridge Priority determines the root bridge, which in turn determines Hello
Time, Max Age and Forward Delay.
Bridge Hello Time Enter an interval (between 1 and 10) in seconds that the root bridge
waits before sending a hello packet.
Bridge Max Age Enter an interval (between 6 and 40) in seconds that a bridge waits to
get a Hello BPDU from the root bridge.
Forward Delay Enter the length of time (between 4 and 30) in seconds that a bridge
remains in the listening and learning port states. The default is 15 seconds.
Bridge Port This is the bridge port type.
RSTP Active Select the check box to enable RSTP on the corresponding port.
RSTP Priority
0(Highest)~240(Lowest) Enter a number between 0 and 240 as RSTP priority for the corresponding
port. 0 is the highest.
RSTP Path Cost
1(Lowest)~65535(Highes
t) Enter a number between 1 and 65535 as RSTP path cost for the
corresponding port. 65535 is the highest.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 29 NETWORK > Bridge (continued)
LABEL DESCRIPTION