ZyXEL Communications 5 Series User Manual
Page 568
ZyWALL 5/35/70 Series User’s Guide
568
Chapter 34 WAN and Dial Backup Setup
Figure 317 Menu 11.3: Remote Node Profile (Backup ISP)
The following table describes the fields in this menu.
Menu 11.3 - Remote Node Profile (Backup ISP)
Rem Node Name= Edit PPP Options= No
Active= No
Edit IP= No
Outgoing: Edit Script Options= No
My Login= ChangeMe
My Password= ******** Telco Option:
Retype to Confirm= ******** Allocated Budget(min)= 0
Authen= CHAP/PAP Period(hr)= 0
Pri Phone #= 0 Schedules=
Sec Phone #= Always On= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel:
Table 209 Menu 11.3: Remote Node Profile (Backup ISP)
FIELD
DESCRIPTION
Rem Node
Name
Enter a descriptive name for the remote node. This field can be up to eight characters.
Active
Press [SPACE BAR] and then [ENTER] to select Yes to enable the remote node or
No to disable the remote node.
Outgoing
My Login
Enter the login name assigned by your ISP for this remote node.
My Password
Enter the password assigned by your ISP for this remote node.
Retype to
Confirm
Enter your password again to make sure that you have entered is correctly.
Authen
This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this
remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
Pri Phone #
Sec Phone #
Enter the first (primary) phone number from the ISP for this remote node. If the
Primary Phone number is busy or does not answer, your ZyWALL dials the
Secondary Phone number if available. Some areas require dialing the pound sign #
before the phone number for local calls. Include a # symbol at the beginning of the
phone numbers as required.
Edit PPP
Options
Move the cursor to this field and use the space bar to select [Yes] and press [Enter] to
edit the PPP options for this remote node. This brings you to Menu 11.3.1 - Remote
Node PPP Options (see
).