ZyXEL Communications 5 Series - Manual (Page 684)

ZyWALL 5/35/70 Series User’s Guide
684 Chapter 48 System Maintenance Menus 8 to 10
Figure 431 Menu 24: System Maintenance
Enter 10 to go to Menu 24.10 - System Maintenance - Time and Date Setting to update the
time and date settings of your ZyWALL as shown in the following screen.
Figure 432 Menu 24.10 System Maintenance: Time and Date Setting
The following table describes the fields in this screen.
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:
Menu 24.10 - System Maintenance - Time and Date Setting
Time Protocol= NTP (RFC-1305)
Time Server Address= 0.pool.ntp.org
Current Time: 08 : 24 : 26
New Time (hh:mm:ss): N/A N/A N/A
Current Date: 2005 - 07 - 27
New Date (yyyy-mm-dd): N/A N/A N/A
Time Zone= GMT
Daylight Saving= No
Start Date (mm-nth-week-hr): Jan. - 1st - Sun. - 00
End Date (mm-nth-week-hr): Jan. - 1st - Sun. - 00
Press ENTER to Confirm or ESC to Cancel: