ZyXEL Communications 5 Series - Manual (Page 472)

ZyWALL 5/35/70 Series User’s Guide
472 Chapter 26 Remote Management
If you allow your ZyWALL to be managed by the Vantage CNM server, then you should not
do any configurations directly to the ZyWALL (using either the web configurator, SMT
menus or commands) without notifying the Vantage CNM administrator.
26.17 Configuring CNM
Vantage CNM is disabled on the device by default. Click ADVANCED > REMOTE MGMT
> CNM to configure your device’s Vantage CNM settings.
Figure 261 ADVANCED > REMOTE MGMT > CNM
The following table describes the labels in this screen.
Table 150 ADVANCED > REMOTE MGMT > CNM
LABEL DESCRIPTION
Registration
Information
Registration Status This read only field displays Not Registered when Enable is not selected.
It displays Registering when the ZyWALL first connects with the Vantage
CNM server and then Registered after it has been successfully registered
with the Vantage CNM server. It will continue to display Registering until it
successfully registers with the Vantage CNM server. It will not be able to
register with the Vantage CNM server if:
The Vantage CNM server is down.
The Vantage CNM server IP address is incorrect.
The Vantage CNM server is behind a NAT router or firewall that does not
forward packets through to the Vantage CNM server.
The encryption algorithms and/or encryption keys do not match between the
ZyWALL and the Vantage CNM server.