ZyXEL Communications 5 Series - Manual (Page 214)

ZyWALL 5/35/70 Series User’s Guide
214 Chapter 10 Wireless LAN
10.16.6 IEEE 802.1x + No WEP
Click the NETWORK > WIRELESS CARD to display the Wireless Card screen. Select
802.1x + No WEP from the Security list.
Figure 100 NETWORK > WIRELESS CARD: 802.1x + No WEP
Idle Timeout
(Seconds) The ZyWALL automatically disconnects a wireless station from the wireless network
after a period of inactivity. The wireless station needs to send the username and
password again before it can use the wireless network again. Some wireless clients
may prompt users for a username and password; other clients may use saved login
credentials. In either case, there is usually a short delay while the wireless client logs
in to the wireless network again.
This value is usually smaller when the wireless network is keeping track of how
much time each wireless station is connected to the wireless network (for example,
using an authentication server). If the wireless network is not keeping track of this
information, you can usually set this value higher to reduce the number of delays
caused by logging in again.
Authentication
Databases Click Local User to go to the Local User Database screen where you can view and/
or edit the list of users and passwords. Click RADIUS to go to the RADIUS screen
where you can configure the ZyWALL to check an external RADIUS server.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 60 NETWORK > WIRELESS CARD: 802.1x + Static WEP (continued)
LABEL DESCRIPTION