ZyXEL Communications 5 Series - Manual (Page 680)

ZyWALL 5/35/70 Series User’s Guide
680 Chapter 48 System Maintenance Menus 8 to 10
The required fields in a command are enclosed in angle brackets <>.
The optional fields in a command are enclosed in square brackets [].
The |symbol means “or”.
For example,
sys filter netbios config
means that you must specify the type of netbios filter and whether to turn it on or off.
48.1.2 Command Usage
A list of commands can be found by typing help or ? at the command prompt. Always type
the full command. Type exit to return to the SMT main menu when finished.
Figure 427 Valid Commands
The following table describes some commands in this screen.
Copyright (c) 1994 - 2005 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys ls exit device
ether poe pptp aux
config ip ipsec bridge
bm idp av as
certificates 8021x radius
ras>
Table 249 Valid Commands
COMMAND DESCRIPTION
sys The system commands display device information and configure device settings.
ls The load sharing commands allow you to configure load balancing.
exit This command returns you to the SMT main menu.
device The device commands deal with the dial backup connection.
ether These commands display Ethernet information and configure Ethernet settings.
poe These commands deal with PPPoE connections.
pptp These commands deal with PPTP connections.
aux These commands display dial backup information and control dial backup connections.
config These commands configure firewall and anti-spam settings.
ip These commands display IP information and configure IP settings.
ipsec These commands display IPSec information and configure IPSec settings.
bridge These commands display bridge information.