Star Micronics Line Thermal/Dot Printer - Manual (Page 99)

Rev. 0.00
3-87
STAR Line Mode Command Specifications
ESC # * LF NUL
[Name] Inquire printer version
[Code]
ASCII ESC # * LF NUL
Hexadecimal 1B 23 2A 0A 00
Decimal 27 35 42 10 0
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Sends printer version.
ESC # *, printer version LF NUL
< Ex: For HSP7000 Ver. 1.0 ESC # *, HSP7000 Ver. 1.0 LF NUL >
ESC ? LF NUL
[Name] Reset printer (execute self print)
[Code]
ASCII ESC ? LF NUL
Hexadecimal 1B 3F 0A 00
Decimal 27 63 10 0
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Hardware resets the printer and executes on self print.
After sending this command, the next data is not sent until the printer is online (in a state wherein it
can receive data).
When resetting the printer, the following processes are performed.
I/F Mode Process
Parallel --- BUSY output
RS-232C DTR mode DTR mark output
Xon/Xoff Mode Xoff output
Executes only a reset; does not execute a self-print.