Star Micronics Line Thermal/Dot Printer - Manual (Page 20)

Rev. 0.00
3-8
STAR LIne Mode Command Specifications
ESC M
[Name] (Thermal) Specify 12 dot pitch/(Slip) specify 7 x 9 font (half dots) (default)
[Code] ASCII ESC M
Hexadecimal 1B 4D
Decimal 27 77
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : -
Validation : -
[Function]
Specifies the right space for ANK 12 x 24 dot fonts in 0 dots.
,
Specifies 7 x 9 (half) dot font.
Sets the number of printable digits in one line to [total half dot count/(10 + character right space
amount).
When page mode is selected, it is fixed at 5 x 9 fonts, and only the setting is valid.
Setting is valid after switching to line mode.
(Note) The settings by this command are valid for all stations.
ESC P
[Name] (Thermal) Specify 15 dot pitch/(Slip) specify 5 x 9 font (2P-1)
[Code] ASCII ESC P
Hexadecimal 1B 50
Decimal 27 80
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : -
Validation : -
[Function]
Specifies the right space for ANK 12 x 24 dot fonts in 3 dots.
,
Specifies 5 x 9 (2 pulse = 1) dot fonts.
Sets the number of printable digits in one line to [total half dot count/(12 + character right space
amount).
(Note) The settings by this command are valid for all stations.