Star Micronics Line Thermal/Dot Printer - Manual (Page 39)

Rev. 0.00
3-27
STAR Line Mode Command Specifications
ESC z n
[Name] Select line feed amount
[Code]
ASCII ESC z n
Hexadecimal 1B 7A n
Decimal 27 122 n
[Defined Area] Thermal : n = 1, 49
Slip : n = 0, 1, n = 48, 49
Validation : n = 0, 1, n = 48, 49
[Initial Value] Thermal : Memory switch setting
Slip : 1/6 inch
Validation : 1/6 inch
[Function]
Specifies the line feed amount.
n Amount of Line Feed
1, 49 Specifies 4 mm line feed amount
,
Specifies the line feed amount.
n Amount of Line Feed
0, 48 Specifies 1/12 inch line feed amount
1, 49 Specifies 1/6 inch line feed amount
Line feed amounts can be set independently for both line mode and page mode.
ESC 0
[Name] (Thermal) Specify 3 mm line feed amount/(Slip) specify 1/8 line feed amount
[Code]
ASCII ESC 0
Hexadecimal 1B 30
Decimal 27 48
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : 1/6 inch
Validation : 1/6 inch
[Function]
Specifies the line feed amount to 3 mm.
,
Specifies the line feed amount to 1/8 inch.
Line feed amounts can be set independently for both line mode and page mode.