Star Micronics Line Thermal/Dot Printer - Manual (Page 52)

Rev. 0.00
3-40
STAR LIne Mode Command Specifications
ESC D NUL
[Name] Clear horizontal tab
[Code]
ASCII ESC D NUL
Hexadecimal 1B 44 00
Decimal 27 68 0
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Clears the currently set horizontal tab.
(Note) The settings using this command are valid for all stations and modes.
ESC GS A n1 n2
[Name] Move absolute position
[Code]
ASCII ESC GS A n1 n2
Hexadecimal 1B 1D 41 n1 n2
Decimal 27 29 65 n1 n2
[Defined Area] Thermal : 0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
Slip : 0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
Validation : 0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Moves the printing position from the left margin to the (n1 + n2 x 256) dot position.
This command is ignored if the print region is exceeded.
The right margin is also the reference for upside-down printing.
The left margin is also the reference for upside-down printing.
,
The right margin is also the reference for upside-down printing.