Star Micronics Line Thermal/Dot Printer - Manual (Page 43)

Rev. 0.00
3-31
STAR Line Mode Command Specifications
ESC 3 n
[Name] Specify n/216 inch paper feed
[Code]
ASCII ESC 3 n
Hexadecimal 1B 33 n
Decimal 27 51 n
[Defined Area] Thermal : -
Slip : 0 ≤ n ≤ 255
Validation : 0 ≤ n ≤ 255
[Initial Value] Thermal : -
Slip : 1/6 inch line feed
Validation : 1/6 inch line feed
[Function]
Three bytes ignored
,
Sets subsequent line feed amounts to a value approximate to n/216 inch.
Because the minimum pitch for the paper feed mechanism is 1/144 of an inch, the setting value will
be approximated according to the following equation.
INT (n x 2/3 + 0.5)/144 of an inch
Line feed amounts can be set independently for both line mode and page mode.
ESC y n
[Name] Specify n/144 inch paper feed
[Code]
ASCII ESC y n
Hexadecimal 1B 79 n
Decimal 27 121 n
[Defined Area] Thermal : -
Slip : 0 ≤ n ≤ 255
Validation : 0 ≤ n ≤ 255
[Initial Value] Thermal : -
Slip : 1/6 inch line feed
Validation : 1/6 inch line feed
[Function]
Three bytes ignored
,
Sets subsequent line feed amounts to a n/144 inch.
Line feed amounts can be set independently for both line mode and page mode.