Star Micronics Line Thermal/Dot Printer - Manual (Page 163)

Rev. 0.00
3-151
STAR Line Mode Command Specifications
3-13) Slip/Validation Function Command Details
ESC SI n
[Name] Set slip sensor
[Code]
ASCII ESC SI n
Hexadecimal 1B 0F n
Decimal 27 15 n
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Three bytes ignored
ESC FF n
[Name] Slip/Validation Function
[Code]
ASCII ESC FF n
Hexadecimal 1B 0C n
Decimal 27 12 n
[Defined Area] Thermal : -
Slip : 2 ≤ n ≤ 5, 50 ≤ n ≤ 53, (“2” ≤ n ≤ “5”)
Validation : 2 ≤ n ≤ 5, 50 ≤ n ≤ 53, (“2” ≤ n ≤ “5”)
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Three bytes ignored
After printing data in the line buffer, the slip paper operation is executed according to the n value.
n Slip Operation
2 to 5
50 to 53
Discharges paper toward the back (the forward direction)
After printing data in the line buffer, the validation printer operation is executed according to the n
value.
n Slip Operation
2 to 5
50 to 53
Discharges paper toward the back (the forward direction)