Star Micronics Line Thermal/Dot Printer - Manual (Page 64)

Rev. 0.00
3-52
STAR LIne Mode Command Specifications
ESC X n1 n2 d1 … dk
[Name] Fine density bit image (Wire-dot, 24 pin compatible)
[Code]
ASCII ESC X n1 n2 d1 .. dk
Hexadecimal 1B 58 n1 n2 d1 .. dk
Decimal 27 88 n1 n2 d1 .. dk
[Defined Area] Thermal : 1 ≤ (n1 + n2 x 256) ≤ printable region
k = {(n1 + n2 x 256) x 3}
0 ≤ d ≤ 255
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Prints input bit images with 8 dots/mm resolution for both horizontal and vertical.
The following shows the details of data processing with this command.
• When {(n1 + n2 x 256) x 3} exceeds the printable region, only the data in the printing region is
printed.
• When {(n1 + n2 x 256) x 3} exceeds the currently set printable region, only the data in the printing
region is printed.
At this time, all data for the print region is discarded.
• If the current position already exceeds the print region, this command discards all data.
,
All data received and discarded.
b7 b6 b4 b3 b2 b1 b0 b5 b7 b6 b4 b3 b2 b1 b0 b5 b7 b6 b4 b3 b2 b1 b0 b5