Star Micronics Line Thermal/Dot Printer - Manual (Page 30)

Rev. 0.00
3-18
STAR LIne Mode Command Specifications
ESC – n
[Name] Specify/cancel underling mode
[Code]
ASCII ESC - n
Hexadecimal 1B 2D n
Decimal 27 45 n
[Defined Area] Thermal : n = 0, 1, 48, 49
Slip : n = 0, 1, 48, 49
Validation : n = 0, 1, 48, 49
[Initial Value] Thermal : n = 0 (Underline cancelled)
Slip : n = 0 (Underline cancelled)
Validation : n = 0 (Underline cancelled)
[Function] Specifies/cancels underline according to n value.
n Underline
0, 48 Cancels underline
1, 49 Specifies underline
Underlines are not applied to horizontal tabs and to specified horizontal direction positions.
This command is valid for ANK characters and Japanese characters and is invalid for IBM blocks.
Underlines are valid for white/black inversion.
Underlines are composed of 2 dot lines.
When character expansion is specified, underlines are also expanded (when in double-high expan-
sion, underlines are composed of four dots.)
,
Underlines are applied to the 9 th dot of the character.
When double-wide expanded characters have been specified, the underline is also expanded, but if
double-tall expanded characters have been selected, the underline does not expand in the vertical
direction. It remains a one-dot line.
(Note) The settings using this command are valid for all stations and modes.