Star Micronics Line Thermal/Dot Printer - Manual (Page 41)

Rev. 0.00
3-29
STAR Line Mode Command Specifications
ESC j n
[Name] Reverse paper feed
[Code]
ASCII ESC j n
Hexadecimal 1B 6A n
Decimal 27 106 n
[Defined Area] Thermal : -
Slip : 0 ≤ n ≤ 255
Validation : 0 ≤ n ≤ 255
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Three bytes ignored
,
Executes a n/72 in reverse direction paper feed.
If print data exists in the line buffer, it prints that data.
This paper feed amount is unaffected even if there are vertical expanded characters in one line.
The single line feed amount setting value is not changed by this command.
ESC I n
[Name] Executes (thermal) n/8 mm line feed/(slip) n/144 line feed one time.
[Code]
ASCII ESC I n
Hexadecimal 1B 49 n
Decimal 27 73 n
[Defined Area] Thermal : 1 ≤ n ≤ 255
Slip : 1 ≤ n ≤ 255
Validation : 1 ≤ n ≤ 255
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Executes paper feed.
If print data exists in the line buffer, it prints that data.
This paper feed amount is unaffected even if there are vertical expanded characters in one line.
The single line feed amount setting value is not changed by this command.
Executes a n/8 mm paper feed.
Using this command will intermittently feed paper, therefore, it is normally recommended that this
command not be used.
(Currently set line feed amount –n/8mm) portion is not printed.
,
Executes a n/144 in paper feed.