Star Micronics Line Thermal/Dot Printer - Manual (Page 137)

Rev. 0.00
3-125
STAR Line Mode Command Specifications
ESC GS / W
[Name] Register Auto Logo setting to non-volatile memory
[Code]
ASCII ESC GS / W
Hexadecimal 1b 1d 2f 57
Decimal 27 29 47 87
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Registers Auto Logo setting to non-volatile memory.
After registration ends, resets the printer.
This command is ignored while Auto Logo is executing.
ESC GS / C
[Name] Initialize Auto Logo setting from non-volatile memory
[Code]
ASCII ESC GS / C
Hexadecimal 1b 1d 2f 43
Decimal 27 29 47 67
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Initializes registered data of the Auto Logo function in the non-volatile memory.
After initialization ends, resets the printer.
This command is ignored while Auto Logo is executing.
The following shows the initial values of the Auto Logo function.
Initial Value
Auto Logo Function OFF
Command Character None
User Macro 1 None
User Macro 2 None
Convert Command Character Do not print
Partial Cut Prior to Auto Logo Printing Invalid