Star Micronics Line Thermal/Dot Printer - Manual (Page 115)

Rev. 0.00
3-103
STAR Line Mode Command Specifications
ESC FF EOT
[Name] Execute EOT mode
[Code]
ASCII ESC FF EOT
Hexadecimal 1B 0C 04
Decimal 27 12 4
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Executes EOT mode.
Executes operation specified by the EOT mode setting command ESC * r E n NUL.
,
Use prohibited.
ESC * r N n NUL
[Name] Discard specified byte count of data
[Code]
ASCII ESC * r N n NUL
Hexadecimal 1B 2A 72 4E n 0
Decimal 27 42 114 78 n 0
[Defined Area] Thermal : 1 ≤ n ≤ 9999
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Discard specified byte count of data
The number of bytes specified by n and later-received data are received and discarded.
n is a decimal description (max. 4 digits) using ASCII characters.
This command is value only when in raster mode.
,
Use prohibited.