Star Micronics Line Thermal/Dot Printer - Manual (Page 102)

Rev. 0.00
3-90
STAR LIne Mode Command Specifications
ESC * r R
[Name] Initialize raster mode
[Code]
ASCII ESC * r R
Hexadecimal 1B 2A 72 52
Decimal 27 42 114 82
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Initializes raster mode.
This command is also valid when not in the raster mode.
However, initialization of the raster mode with this command is executed when entering the raster
mode.
The following settings are initialized using this command.
• Raster page length setting (ESC * r P n NUL)
• Raster print quality setting (ESC * Q n NUL)
• Raster print quality setting (ESC * r K n NUL)
• Raster left margin setting (ESC * r m l n NUL)
• Raster right margin setting (ESC * r m r n NUL)
• Raster EOT mode setting (ESC FF EOT)
• Raster FF mode setting (ESC FF NUL)
• Clear raster image buffer
Note that when entering the raster mode, it executes the same process as initialization of the raster
mode using this command.
However, because initialization is not performed when entering the raster mode only for the following
settings, when initializing the following it sends this initialization command.
• Raster print quality setting (ESC * r K n NUL)
,
Use prohibited.