Star Micronics Line Thermal/Dot Printer - Manual (Page 26)

Rev. 0.00
3-14
STAR LIne Mode Command Specifications
SO
[Name] Set double wide
[Code]
ASCII SO
Hexadecimal 0E
Decimal 14
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Cancels 2x wide expansion
Slip : Cancels 2x wide expansion
Validation : Cancels 2x wide expansion
[Function] Specifies double wide for ANK characters and Kanji characters.
This command is equivalent to ESC W 1.
(Note) The settings using this command are valid for all stations and modes.
DC4
[Name] Cancel expanded wide
[Code] ASCII DC4
Hexadecimal 14
Decimal 20
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Cancels 2x wide expansion
Slip : Cancels 2x wide expansion
Validation : Cancels 2x wide expansion
[Function] Cancels expanded wide if the following commands specify expanded wide.
• Double wide specifying command (SO)
• Set/cancel double wide (ESC W)
• Set/cancel double wide/high (ESC i)
This command is equivalent to ESC W 0.
(Note) The settings using this command are valid for all stations and modes.