Star Micronics Line Thermal/Dot Printer - Manual (Page 122)

Rev. 0.00
3-110
STAR LIne Mode Command Specifications
3-6) 2-Color Printing Command Details
The following commands control 2-color printing functions.
The following commands are effective only when using a model handling 2-color printing.
ESC RS c n
[Name] Set print color in 2-color print mode
[Code]
ASCII ESC RS c n
Hexadecimal 1B 1E 63 n
Decimal 27 30 99 n
[Defined Area] Thermal : 0 ≤ n ≤ 1, 48 ≤ n ≤ 49, (“0” ≤ n ≤ “1”)
Slip : -
Validation : -
[Initial Value] Thermal : n = 0, 48 (When in 2-color print mode)
Slip : -
Validation : -
[Function]
Specifies print color in 2 color print mode.
This command is ignored when not in the 2-color print mode.
Specifies black for the print color when in 2-color print mode.
The specification of this command is cleared only when the printer is reset.
The specification of this command is not cleared by ESC @ CAN.
However, print color is initialized to black by the ESC @ and CAN only when in the compatible 2-
color print mode.
n Specifies 2-color print mode color
0, 48 Black
1, 49 Red
,
Only setting is valid
Setting is valid after switching to thermal.