Star Micronics Line Thermal/Dot Printer - Manual (Page 21)

Rev. 0.00
3-9
STAR Line Mode Command Specifications
ESC :
[Name] (Thermal) Specify 16 dot pitch/(Slip) specify 5 x 9 font (3P-1)
[Code]
ASCII ESC :
Hexadecimal 1B 3A
Decimal 27 58
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : -
Validation : -
[Function]
Specifies the right space for ANK 12 x 24 dot fonts in 4 dots.
,
Specifies 5 x 9 (3 pulse = 1) dot fonts.
Sets the number of printable digits in one line to [total half dot count/(18 + character right space
amount).
(Note) The settings by this command are valid for all stations.
ESC g
[Name] Specify 14 dot pitch
[Code]
ASCII ESC g
Hexadecimal 1B 67
Decimal 27 103
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : -
Validation : -
[Function]
Specifies rights space for the ANK 12 x 24 dot fonts to 2 dots.
,
Only setting is valid
Setting is valid after switching to thermal.