Star Micronics Line Thermal/Dot Printer - Manual (Page 42)

Rev. 0.00
3-30
STAR LIne Mode Command Specifications
ESC A n
[Name] Defines (thermal) a 3 mm/4 mm line feed amount/Defines (slip) n/72 inch pitch line feed
[Code]
ASCII ESC A n
Hexadecimal 1B 41 n
Decimal 27 65 n
[Defined Area] Thermal : 0 ≤ n ≤ 255
Slip : 0 ≤ n ≤ 85
Validation : 0 ≤ n ≤ 85
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Defines the line feed amount.
The line feed amount defined using this command is specified to the current line feed amount by the
ESC 2 command.
n Amount of Line Feed
0 ≤ n ≤ 9 Defines a 3 mm line feed amount
10 ≤ n Defines a 4 mm line feed amount
,
Defines line feed amount for one line as n/72 inch.
Line feed amounts can be set independently for both line mode and page mode.
ESC 2
[Name] Specify line feed amount (ESC A n)
[Code]
ASCII ESC 2
Hexadecimal 1B 32
Decimal 27 50
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : 1/6 inch line feed
Validation : 1/6 inch line feed
[Function] Specifies the line feed amount to the value defined by ESC A n.