Star Micronics Line Thermal/Dot Printer - Manual (Page 143)

Rev. 0.00
3-131
STAR Line Mode Command Specifications
ESC GS / 6 n
[Name] Partial cut setting just prior to Auto Logo printing
[Code]
ASCII ESC GS / 6 n
Hexadecimal 1b 1d 2f 36 n
Decimal 27 29 47 54 n
[Defined Area] Thermal : 0 ≤ n ≤ 1
Slip : -
Validation : -
[Initial Value] Thermal : n = 0
Slip : -
Validation : -
[Function]
Sets the partial cut setting just prior to Auto Logo printing
This setting is registered to non-volatile memory by the ESC GS / W command.
This command is ignored while Auto Logo is executing.
n Setting
0 Does not execute partial cut just prior to Auto Logo printing
1 Executes partial cut just prior to Auto Logo printing
***************
MACDONALDS
***************
1.CHEESBUGER $2.00
2.COKE $1.00
- -- -- -- --- -- -- --- -- -- -
TOTAL $3.00
********************
MCDONALD’S
********************
1. CHEESEBURGER $2.00
2.COKE $1.00
-----------------------------------
TOTAL $3.00
Header
Header
COKE
Cheeseburger
Logo2 is printed
Logo3 is printed
Partial Cut
Partial Cut
Header
********************
MCDONALD’S
1. AutoLogo triggered by cut
command
2. User macro 1 is executed
4. User macro 2 is executed.
Paper is cut.
Head logo is printed
3. AutoLogo is printed.