Star Micronics Line Thermal/Dot Printer - Manual (Page 54)

Rev. 0.00
3-42
STAR LIne Mode Command Specifications
ESC GS a n
[Name] Specify position alignment
[Code]
ASCII ESC GS a n
Hexadecimal 1B 1D 61 n
Decimal 27 29 97 n
[Defined Area] Thermal : 0 ≤ n ≤ 2, 48 ≤ n ≤ 50, (“0” ≤ n ≤ “2”)
Slip : 0 ≤ n ≤ 2, 48 ≤ n ≤ 50, (“0” ≤ n ≤ “2”)
Validation : 0 ≤ n ≤ 2, 48 ≤ n ≤ 50, (“0” ≤ n ≤ “2”)
[Initial Value] Thermal : n = 0
Slip : n = 0
Validation : n = 0
[Function] This specifies position alignment for all print data in one line, in the set print region.
n Position alignment
0, 48 Left alignment
1, 49 Center alignment
2, 50 Right alignment
,
When page mode is selected, only setting is valid
Setting is valid after switching to line mode.
(Note) The settings by this command are valid for all stations.
ABC
ABCD ” a” 0
ABCDE
ABC
“a” 1 ABCD
ABCDE
ABC
“ a” 2 ABCD
ABCDE