Star Micronics Line Thermal/Dot Printer - Manual (Page 72)

Rev. 0.00
3-60
STAR LIne Mode Command Specifications
3-3-11) Cutter Control
ESC d n
[Name] Auto-cutter:
[Code]
ASCII ESC d n
Hexadecimal 1B 64 n
Decimal 27 100 n
[Defined Area] Thermal : 0 ≤ d ≤ 3,
48 ≤ d ≤ 51 (“0” ≤ d ≤ “3”)
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
Executes the auto-cutter.
After auto-cutter is executed, the printer considers that position to be the top of the page.
n Auto-cutter
0, 48 Full cut at the current position.
Print data in line buffer is printed before a full cut.
Models not provided the auto-cutter execute only functions other than the cutting operation
(printing/paper feed operations).
1, 49 Partial cut at the current position.
Print data in line buffer is printed before a partial cut.
Models not provided the auto-cutter execute only functions other than the cutting operation
(printing/paper feed operations).
2, 50 Paper is fed to cutting position, then a full cut.
Print data in line buffer is printed before the operation described above.
Models not provided the auto-cutter execute only functions other than the cutting operation
(printing/paper feed operations).
3, 51 Paper is fed to cutting position, then a partial cut.
Print data in line buffer is printed before the operation described above.
Models not provided the auto-cutter execute only functions other than the cutting operation
(printing/paper feed operations).
(*) The auto-cutter function operates in the following ways on models that only have a full cut or a
partial cut.
• Models that perform only a full cut.: Executes a full cut when for instructions calling for a
partial cut.
• Models that perform only a partial cut.: Executes a partial cut when for instructions calling
for a full cut.
,
Three bytes ignored