Star Micronics Line Thermal/Dot Printer - Manual (Page 76)

Rev. 0.00
3-64
STAR LIne Mode Command Specifications
ESC GS BEL m t1 t2
[Name] Ring buzzer
[Code]
ASCII ESC GS BEL m t1 t2
Hexadecimal 1B 1D 07 m t1 t2
Decimal 27 29 7 m t1 t2
[Defined Area] Thermal : 1 ≤ m ≤ 2, 49 ≤ m ≤ 50 (“1” ≤ m ≤ “2”)
1 ≤ t1 ≤ 255, 1 ≤ t2 ≤ 255
Slip : 1 ≤ m ≤ 2, 49 ≤ m ≤ 50 (“1” ≤ m ≤ “2”)
1 ≤ t1 ≤ 255, 1 ≤ t2 ≤ 255
Validation : 1 ≤ m ≤ 2, 49 ≤ m ≤ 50 (“1” ≤ m ≤ “2”)
1 ≤ t1 ≤ 255, 1 ≤ t2 ≤ 255
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Rings buzzer.
m specifies the buzzer drive terminal.
m Buzzer Drive Terminals
1, 49 Buzzer drive terminal 1
2, 50 Buzzer drive terminal 2
t1 specifies the energizing time; t2 specifies the delay time.
• Energizing time = 20 msec x t1
• Delay time = 20 msec x t2
Buzzer cannot ring whle printer is printing.
This command is prohibited for use for anything other than ringing the buzzer.
(When this command is used for the drawer drive on models equipped with an external device
terminal, it will be damaged, so care is needed.) )
20 × t2 (msec) 20 × t1 (msec)
Printing and Paper Feed Prohibited
(Energizing Time (Delay Time)
OFF
ON
Drive Pulse
Print Operation