Star Micronics Line Thermal/Dot Printer - Manual (Page 40)

Rev. 0.00
3-28
STAR LIne Mode Command Specifications
ESC 1
[Name] (Thermal) Specify 3 mm line feed amount/(Slip) specify 7/72 inch line feed amount
[Code]
ASCII ESC 1
Hexadecimal 1B 31
Decimal 27 49
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : 1/6 inch
Validation : 1/6 inch
[Function]
Specifies the line feed amount to 3 mm.
,
Specifies the line feed amount to 7/72 in.
Line feed amounts can be set independently for both line mode and page mode.
ESC J n
[Name] (Thermal) n/4 mm line feed/(Slip) execute n/72 line feed one time
[Code]
ASCII ESC J n
Hexadecimal 1B 4A n
Decimal 27 74 n
[Defined Area] Thermal : 1 ≤ n ≤ 255
Slip : 1 ≤ n ≤ 255
Validation : 1 ≤ n ≤ 255
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Execute paper feed.
If print data exists in the line buffer, it prints that data.
This paper feed amount is unaffected even if there are vertical expanded characters in one line.
The single line feed amount setting value is not changed by this command.
Executes a n/4mm paper feed.
Using this command will intermittently feed paper, therefore, it is normally recommended that this
command not be used.
(Currently set line feed amount –n/4 mm) portion is not printed.
,
Executes a n/72 in paper feed.