Star Micronics Line Thermal/Dot Printer - Manual (Page 81)

Rev. 0.00
3-69
STAR Line Mode Command Specifications
3-3-14) Status
ESC RS a n
[Name] Set status transmission conditions
[Code]
ASCII ESC RS a n
Hexadecimal 1B 1E 61 n
Decimal 27 30 97 n
[Defined Area] Thermal : 0 ≤ n ≤ 3, 48 ≤ n ≤ 51, (“0” ≤ n ≤ “51”)
Slip : 0 ≤ n ≤ 3, 48 ≤ n ≤ 51, (“0” ≤ n ≤ “51”)
Validation : 0 ≤ n ≤ 3, 48 ≤ n ≤ 51, (“0” ≤ n ≤ “51”)
[Initial Value] Thermal : DIPS switches/Memory switch setting
Slip : DIPS switches/Memory switch setting
Validation : DIPS switches/Memory switch setting
[Function] Sets the status transmission conditions. See Appendix 2 for details regarding ASB status.
This command is effective only on printers that have an interface capable of bi-directional data
communications.
When using serial, parallel or USB (vendor class), use is possible.
The command is ignored (set to enable auto-status) when using Ethernet or wireless LAN.
Settings of this command are unaffected by the ESC @ (command initialization) command.
See each printer’s product specifications manual for details on the memory switch settings.
(Note) The settings using this command are valid for all stations and modes.