Star Micronics Line Thermal/Dot Printer - Manual (Page 88)

Rev. 0.00
3-76
STAR LIne Mode Command Specifications
ESC t n1 n2
[Name] Set single-byte Kanji characters left/right spaces
[Code]
ASCII ESC t n1 n2
Hexadecimal 1B 74 n1 n2
Decimal 27 116 n1 n2
[Defined Area] Thermal : 0 ≤ n1 ≤ 7, 48 ≤ n1 ≤ 55 (“0” ≤ n1 ≤ “7”)
0 ≤ n2 ≤ 15, 48 ≤ n2 ≤ 57 (”0” ≤ n2 ≤ “9”), 65 ≤ n2 ≤ 70 (”A” ≤ n2 ≤ “F”)
Slip : 0 ≤ n1 ≤ 7, 48 ≤ n1 ≤ 55 (“0” ≤ n1 ≤ “7”)
0 ≤ n2 ≤ 15, 48 ≤ n2 ≤ 57 (”0” ≤ n2 ≤ “9”), 65 ≤ n2 ≤ 70 (”A” ≤ n2 ≤ “F”)
Validation : 0 ≤ n1 ≤ 7, 48 ≤ n1 ≤ 55 (“0” ≤ n1 ≤ “7”)
0 ≤ n2 ≤ 15, 48 ≤ n2 ≤ 57 (”0” ≤ n2 ≤ “9”), 65 ≤ n2 ≤ 70 (”A” ≤ n2 ≤ “F”)
[Initial Value] Thermal : Memory switch setting
Slip : Memory switch setting
Validation : Memory switch setting
[Function] Adds n1 dot left space and n2 dot right space to single-byte Kanji characters.
See each printer’s product specifications manual for details on the memory switch settings.
This command is ignored for models not equipped with Japanese and Kanji characters and when
the specification for the location of use is specified as SBCS (single byte countries) by the memory
switch.
,
The values of n1 and n2 when using two-byte 8 x 16, two-byte 16 x 16 and double-tall 8 x 16 charac-
ters correspond to the n1 and n2 values for double high/double wide 16 x 16 characters.
If the Japanese character size including the right and left spaces (n1 + character width + n2) ex-
ceeds the print region, printing will not be possible and a question mark (“?”) will be printed instead.
When page mode is selected, only setting is valid
Setting is valid after switching to line mode.
(Note) The settings by this command are valid for all stations.