Star Micronics Line Thermal/Dot Printer - Manual (Page 79)

Rev. 0.00
3-67
STAR Line Mode Command Specifications
3-3-13) Print Settings
ESC RS d n
[Name] Set print density
[Code]
ASCII ESC RS d n
Hexadecimal 1B 1E 64 n
Decimal 27 30 100 n
[Defined Area] Thermal : 0 ≤ n ≤ 15
48 ≤ n ≤ 57 (”0” ≤ n ≤ “9”), 65 ≤ n ≤ 70 (”A” ≤ n ≤ “F”)
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : -
Validation : -
[Function]
Sets print density.
This command stops printing to be executed.
n Print Density
0, 48 Print density 1.3
1, 49 Print density 1.2
2, 50 Print density 1.1
3, 51 Print density 1.0
4, 52 Print density 0.9
5, 53 Print density 0.8
6, 54 Print density 0.7
7, 55 (Reserved)
8, 56 (Reserved)
9, 57 (Reserved)
10, 65 (Reserved)
11, 66 (Reserved)
12, 67 (Reserved)
13, 68 (Reserved)
14, 69 (Reserved)
15, 70 (Reserved)
,
Only setting is valid
Setting is valid after switching to thermal.