Star Micronics Line Thermal/Dot Printer - Manual (Page 32)

Rev. 0.00
3-20
STAR LIne Mode Command Specifications
ESC 4
[Name] (Thermal) Specify black/white inversion/(Slip) specify black/white inversion, red/black color ( substitute function )
[Code] ASCII ESC 4
Hexadecimal 1B 34
Decimal 27 52
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : White/black inversion cancelled
Slip : White/black inversion cancelled/black color printing specified
Validation : White/black inversion cancelled/black color printing specified
[Function]
Specifies white/black inversion for ANK characters and Kanji characters.
IBM block ignores white/black inversion.
,
This command function is based on the selection of red/black substitute function.
The red/black substitute function is selected by the memory switch or the command ESC GS 4 m n.
For details on selecting the red/black substitute function using a command, see the explanation of
ESC GS 4 below, and for details on selecting the red/black substitute function using the memory
switch, see the printer specifications manual.
(Note) The settings using this command are valid for all stations and modes.
ESC 5
[Name] (Thermal) Cancel black/white inversion/(Slip) cancel black/white inversion, red/black color (substitute function)
[Code] ASCII ESC 5
Hexadecimal 1B 35
Decimal 27 53
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : White/black inversion cancelled
Slip : White/black inversion cancelled/black color printing specified
Validation : White/black inversion cancelled/black color printing specified
[Function]
Cancels white/black inversion for ANK characters and Kanji characters.
,
This command function is based on the selection of red/black substitute function.
The red/black substitute function is selected by the memory switch or the command ESC GS 4 m n.
For details on selecting the red/black substitute function using a command, see the explanation of
ESC GS 4 below, and for details on selecting the red/black substitute function using the memory
switch, see the printer specifications manual.
(Note) The settings using this command are valid for all stations and modes.