Star Micronics Line Thermal/Dot Printer - Manual (Page 95)

Rev. 0.00
3-83
STAR Line Mode Command Specifications
ESC @
[Name] Command initialization
[Code]
ASCII ESC @
Hexadecimal 1B 40
Decimal 27 64
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Initializes each command after printing data in the line buffer.
However, printers with memory switch settings are initialized to the memory switch settings.
DIPSW re-loading is not performed.
After execution, thermal is selected.
• ANK characters, Kanji character adornment, expansion
• Kanji character mode
• ANK right space
• Kanji character right and left spaces
• Character pitch
• International characters
• Code pages
• Set slash zero
• Set specify/cancel external character (external register character data is retained)
• Line feed amount
• Set upside-down, position alignment
• Right/left margins
• Horizontal tab
• Page length
• Current position (move to top of page, top of line)
• Vertical tab
,
• Paper discharge
The following shows the specifications that are not initialized by this command.
• Set print density
• Set print speed
• Two Color Printing Mode Setting
• Printing color in 2-color printing mode
• External device drive condition
• Auto status valid/invalid conditions