Star Micronics Line Thermal/Dot Printer - Manual (Page 69)

Rev. 0.00
3-57
STAR Line Mode Command Specifications
ESC RS L m
[Name] Logo batch control
[Code]
ASCII ESC RS L m
Hexadecimal 1B 1E 4C m
Decimal 27 30 76 m
[Defined Area] Thermal : 0 ≤ m ≤ 3, 48 ≤ m ≤ 51, (“0” ≤ m ≤ “3”), m = 255
Slip : 0 ≤ m ≤ 3, 48 ≤ m ≤ 51, (“0” ≤ m ≤ “3”), m = 255
Validation : 0 ≤ m ≤ 3, 48 ≤ m ≤ 51, (“0” ≤ m ≤ “3”), m = 255
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Controls logos specified by the parameter m.
After execution, resets the printer.
m: Print Mode
m Logo Control Mode
0, 48 Normal mode batch printing
1, 49 Horizontal double size mode batch printing
2, 50 Vertical double size mode batch printing
3, 51 Double high/wide mode batch printing
255 Logo batch delete
• If the parameter is within the defined region, execute this command after printing the unprinted data
in the line buffer.
(Unprinted data is printed regardless of whether the specified logo was registered by n.) )
• Form feed obeys the vertical print size of the logo.
• Print modes, excluding upside-down printing (enhanced, double, underline, character size, black/
white inverted, and 90˚ right rotation) are unaffected by logos.
• Prints logo number as shown below in the line above each logo print.
This line is printed with ANK characters, so currently set adornment is applied.
(Print Ex.) “LOGO No. 1” (Each logo number is printed at the “1” position.)
• If the logo horizontal print size exceeds the horizontal print region, the portion exceeding the area is
not printed.
• This test print is affected by the following command settings.
• Left margin (ESC I n)
• Right margin (ESC Q n)
• Position alignment (ESC GS a n)
• Print region setting (ESC RS A n)
• Upside-down printing (SI)
• After batch printing output is ended, paper is fed automatically to the cutting position, paper is cut (if
the printer is equipped with a cutter), and the printer is reset.
,
When page mode is selected, four bytes ignored.