Siemens Brodersen MC55 AT - Manual (Page 90)

MC55_ATC_V04.00 Page 90 of 475 3/17/06
Confidential / Released
4.6 AT+ILRR Set TE-TA local rate reporting
The command
AT+ILRR
controls whether or not the intermediate result code "
+ILRR
" is transmitted from the TA
to the TE while a connection is being set up. The result code indicates the local rate. It is issued before the final
result code of the connection, e.g. CONNECT, is transmitted to the TE.
Syntax
Intermediate Result Code
+ILRR:
Indicates local port rate setting upon connection setup.
Parameter Description
0 (&F) Disables reporting of local port rate
1 Enables reporting of local port rate
Port rate setting upon connection setup (bps)
0
Autobauding (see Section 4.7.1 , Autobauding ). Not supported on ASC1.
300
600
1200
2400
4800
9600
14400
Test Command
AT+ILRR=?
Response(s)
+ILRR:
(list of supported s)
OK
Read Command
AT+ILRR?
Response(s)
+ILRR:
OK
Write Command
AT+ILRR=
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
V.250 % % ! % ! ! ! ! !
(num)(&W)(&V)
(num)