Siemens Brodersen MC55 AT - Manual (Page 251)

MC55_ATC_V04.00 Page 251 of 475 3/17/06
Confidential / Released
10.9 AT^SISE Internet Service Error Report
The
AT^SISE
write command returns the current error status of the specified Internet service profile. If the ser-
vice profile is not defined or the value is invalid "+CME ERROR" response is returned.
The error status is identical to the content of the "
^SIS
" URC last issued.
If a service fails the commands
AT^SISR
or
AT^SISW
will return an error response. However, if the
AT^SISE
command returns =0 it is recommended to use the
AT+CEER
command because a general GSM/
GPRS problem might be the reason.
Syntax
Parameter Description
Internet service profile identifier as defined by
AT^SISS
.
0...9
Reason for Internet service error. This is a subset of the s which can be found in Section 10.10 ,
Internet Service URC "^SIS" .
The value 0 indicates there is no special Internet service error. In this case the application may use
AT+CEER
to check for general GSM/GPRS problems.
Information text related to . This is a subset of the s which can be found in Section
10.10 , Internet Service URC "^SIS" .
Note
• In particular cases, the
AT^SISE
command may deliver information and warnings. This applies the following
services:
FTP: Information 2100
POP3: Warnings
SMTP: Warnings
If an error occurs the information and warning messages are overwritten by error messages.
Test Command
AT^SISE=?
Response(s)
OK
Write Command
AT^SISE=
Response(s)
^SISE:
, [, ]
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
! % % % % % ! ! !
(num)
(num)
(str)