See also, At^slcc, If configured with – Siemens Brodersen MC55 AT User Manual
Page 149
MC55_ATC_V04.00
Page 149 of 475
3/17/06
Confidential / Released
7.21
AT^SLCC Siemens defined command to list current calls of ME
covers essentially the same information as GSM 07.07 command
, with the following addi-
tions:
• The execute command response contains an additional parameter
indi-
cating whether the call has been assigned a traffic channel by the network (transmission of data or inband
information is possible).
• The additional write command allows to activate Event reporting for the list of current calls. If event reporting
is active for an interface, a call status transition (cf.
) and (if desired) the
assignment of a traffic channel will generate an event report indication to this interface. In order to receive
this event report as an URC, the URC presentation mode for this interface has to be configured with
The frequency of event report generation can be configured with AT command
. Refer to
for further detail on the configuration options.
• The additional read command allows to determine the event reporting mode
which indicates whether the
interface receives event report indications for the list of current calls. Mind that the URC will be displayed only
if the URC presentation mode for the interface concerned has been configured with
.
Syntax
Test Command
AT^SLCC=?
Response(s)
^SLCC:
(list of supported
OK
Read Command
AT^SLCC?
Response(s)
OK
Exec Command
AT^SLCC
Response(s)
,
,
]]]
,
,
]]]
[^SLCC:...]
OK
ERROR
+CME ERROR
Write Command
AT^SLCC=
]
Response(s)
OK
ERROR
+CME ERROR:
Reference(s)
PIN
ASC0 ASC1
MUX1
MUX2
MUX3 Charge
Last
Siemens
%
%
%
%
%
%
!
!
!