Siemens Brodersen MC55 AT - Manual (Page 335)

MC55_ATC_V04.00 Page 335 of 475 3/17/06
Confidential / Released
13.2 AT+CMGC Send an SMS command
Syntax
Notes
• After invoking the commands
AT+CMGW
,
AT+CMGS
or
AT+CMGC
it is necessary to wait for the prompt ">"
before entering text or PDU. After the prompt a timer will be started to observe the input.
• At baudrates below 19200 it is recommended to use the line termination character only (refer to
ATS3
, default
) before entering the text or PDU. Use of the line termination character followed by the response format-
ting character (refer to
ATS4
, default can cause problems
Test Command
AT+CMGC=?
Response(s)
OK
Write Command
If text mode (see
AT+CMGF
=1)
AT+CMGC=
, [, [, [, [, ]]]] Text can be entered /
Response(s)
+CMGC:
[, ]
If sending fails
ERROR
+CMS ERROR
Write Command
If PDU mode (see
AT+CMGF
=0)
AT+CMGC= R>
PDU can be entered /
Response(s)
+CMGC:
[, ]
OK
If sending fails
ERROR
+CMS ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
GSM 07.05 % % % % % % ! ! !