10 internet service urc "^sis, Urccause, With – Siemens Brodersen MC55 AT User Manual
Page 252: Cause, Urcinfoid, The urc as parameter, Rc parameter, Internet service urc "^sis
MC55_ATC_V04.00
Page 252 of 475
3/17/06
Confidential / Released
10.10
Internet Service URC "^SIS"
This section first describes the syntax and the parameters of the "
" URC. The second part consists of tables
listing the information elements delivered within the "
" URC and the command response of
.
The presentation of the "
" URC containing the parameter
=0 can be disabled or enabled
depending on whether polling mode or URC mode is preferred. To do so, use the
command, parameter
"Tcp/WithURCs" (refer to
=1 or 2, the "
" URC will
always be delivered regardless of the setting made with
Unsolicited Result Code
Indicates an event, an error or an information element. The same information can be obtained via
[, [
][,
The URC may appear if an event or an error occurs, for example after opening an Internet service with
or any time during operation. The URC also indicates a request for a mobile terminated Internet service client
connection, or a failure if a mobile terminated request is rejected. Furthermore, the URC may deliver an informa-
tion element resulting from a specific command given in the service profile.
A list of possible causes can be found in the tables below. The tables contain the
and, if applica-
ble, a specific
. If marked with *) the precise text related to a
varies greatly
depending on the scenario and the implementation of the remote server. In these cases, only a brief explanation
of the scenario can be found in the table column "Description".
Parameter Description
URC cause identifier.
0
An event has occurred after opening or while using an Internet service.
The event number is presented via
and may be an error, a
warning, an information element or a note. Optionally additional information
may be supplied via
1
Indicates that an opened Socket listener service is receiving a connection
request from a remote client.
The incoming socket connection is dynamically assigned to the next free Inter-
net service profile. In this case, the parameter
inside the "
URC equals the
of the dynamically assigned service pro-
file. This ID shall be used to accept the connection request with
or to
reject it with
.
The connection status may be requested by using the
read or write
command or the
read command. Among other details, the response
indicates the IP address of the remote client (parameter
may be helpful to decide whether to accept or reject the request.
2
Incoming Socket service client connection has failed. The client request was
rejected automatically because no free Internet service profile was available.
Information identifier related to
. See tables below for further detail. The
number
ranges indicate the type of information element:
0: Service is working properly.
1 - 2000: Error, service is aborted and enters
=6 (Down).
2001 - 4000: Information related to progress of service.
4001 - 6000: Warning, but no service abort.
6001 - 8000: Notes
Additional information for Socket service: As stated above, if a Socket connection request from a remote client
is received (see
=1) the
equals the
of the dynamically assigned
free service profile.
(num)
(num)