Siemens Brodersen MC55 AT - Manual (Page 359)

MC55_ATC_V04.00 Page 359 of 475 3/17/06
Confidential / Released
Broadcast Type Messages:
0
Type not supported
1 Type supported
Notes
• If CSMS mode is switched from Phase 2+ to Phase 2 and one or more
AT+CNMI
Parameter are Phase 2+
specific a '+CMS ERROR: unknown error' will appear. It is recommended to switch the
AT+CNMI
Parameters
to Phase 2 specific values before entering Phase 2.
• Phase 2+ ( =1) must be set before the following features can be used:
- Configuring procedures for indicating received short messages with the
AT+CNMI
parameters =2 or
=3 and =1.
- Acknowledging incoming short messages with
AT+CNMA
.
- Receiving Status Reports and acknowledging them with
AT+CNMA
.
(num)