Siemens Brodersen MC55 AT - Manual (Page 49)

MC55_ATC_V04.00 Page 49 of 475 3/17/06
Confidential / Released
2.12 AT+CSCS Select TE character set
The
AT+CSCS
write command informs the TA which character set is used by the TE. This enables the
TA to convert character strings correctly between TE and ME character sets. See also Section 1.5 , Supported
character sets .
Note that when the TA-TE interface is set to 8-bit operation and the used TE alphabet is 7-bit, the highest bit will
be set to zero.
Syntax
Parameter Description
"GSM" (&F)(P) GSM default alphabet (GSM 03.38 subclause 6.2.1);
Note: This setting may cause software flow control problems since the codes
used to stop and resume data flow (XOFF = decimal 19, XON = decimal 17)
are interpreted as normal characters.
"UCS2" 16-bit universal multiple-octet coded character set (ISO/IEC10646 [32]); UCS2
character strings are converted to hexadecimal numbers from 0000 to FFFF;
e.g. "004100620063" equals three 16-bit characters with decimal values 65, 98
and 99.
Test Command
AT+CSCS=?
Response(s)
+CSCS:
(list of supported s)
OK
Read Command
AT+CSCS?
Response(s)
+CSCS:
OK
Write Command
AT+CSCS=
[ ]
Response(s)
OK
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
GSM 07.07, GSM 11.11 ! % % % % % ! ! !
(str)