Siemens Brodersen MC55 AT - Manual (Page 383)

MC55_ATC_V04.00 Page 383 of 475 3/17/06
Confidential / Released
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with
ATD>
is, depending
on the network, not always possible (refer to GSM 04.08 subclause 10.5.4.7 for details). See also of
AT+CPBW
.
Possible values are:
145
Dialing string includes international access code character '+'
161 National number. Network support of this type is optional.
209 Dialing string has been saved as ASCII string and includes non-
digit characters other than "*", "#" or "+". Note that phonebook entries saved
with this type cannot be dialed.
255 Dialing string is a command to control a Supplementary Service,
i.e. "*", "#" codes are contained. Network support of this type is optional.
129 Otherwise
Text assigned to a phone number. The maximum length for this parameter is given with test command response
parameter .
If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via
escape sequences as described in Section 1.5 , Supported character sets .
Maximum location number for the currently selected storage. For phonebooks located on the SIM this value
depends on the SIM card type.
Maximum length of phone number for "normal" locations. Depending on the storage a limited number of loca-
tions with extended memory is available per phonebook. These locations allow storing numbers with twice the
standard length, which is 2* digits for normal numbers, but only digits for numbers
saved with =209.
Maximum length of assigned to the telephone number. The value indicated by the test command is
given in octets. If is given as GSM characters each character corresponds to one octet. If the
string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha
field of the SIM according to GSM 11.11, Annex B [21] . In the worst case the number of UCS2 characters is at
least one less than half the number of GSM characters.
Note
• Users should be aware that when using this AT command quickly after SIM PIN authentication the SIM data
may not yet be accessible, resulting in a short delay before the requested AT command response is returned.
See Section 20.1 , Restricted access to SIM data after SIM PIN authentication for further detail.
(num)
(str)(+CSCS)
(num)
(num)
(num)