Siemens Brodersen MC55 AT - Manual (Page 148)

MC55_ATC_V04.00 Page 148 of 475 3/17/06
Confidential / Released
3 Voice followed by data, voice mode (only in connection with single numbering
scheme
AT+CSNS
)
4 Alternating voice/data, voice mode (only in connection with single numbering
scheme
AT+CSNS
)
5 Alternating voice/fax, voice mode (only in connection with single numbering
scheme
AT+CSNS
)
6 Voice followed by data, data mode (only in connection with single numbering
scheme
AT+CSNS
)
7 Alternating voice/data, data mode (only in connection with single numbering
scheme
AT+CSNS
)
8 Alternating voice/fax, fax mode (only in connection with single numbering
scheme
AT+CSNS
)
9 Unknown
0 Call is not one of multiparty (conference) call parties
1 Call is one of multiparty (conference) call parties
Phone number in format specified by
Type of address octect
145
Dialing string includes international access code character '+'
129 Otherwise
Alphanumeric representation of corresponding to the entry found in phonebook; used character set
should be the one selected with command
AT+CSCS
(Select TE Character Set).
The maximum displayed length of is 16 characters. If has more than 16 characters, only the
first 15 characters are displayed. To indicate an overflow, a special character will be used as the 16th character.
This is a space if the character set selected with
AT+CSCS
is 'GSM', or 'E400' if the character set is 'UCS2'.
Due to time constraints on the necessary evaluation of the phonebook, this parameter may show a default value
in early call phases (e.g. for = ''dialing'', ''incoming'' or ''alerting''), even if a phonebook entry is present
for the number concerned.
Note
• Teleservices other than voice, data, fax are not fully supported by ME. They are used only in connection with
the handling for
AT+CSNS
, and may therefore occur in parameter for mobile terminated calls.
(num)
(str)
(num)
(str)(+CSCS)