1, the, Mode, Cnmi – Siemens Brodersen MC55 AT User Manual
Page 349
MC55_ATC_V04.00
Page 349 of 475
3/17/06
Confidential / Released
URC 4
=2 (PDU mode enabled):
Indicates that new cell broadcast message has been received
URC 5
=2 (text mode enabled):
Indicates that new cell broadcast message has been received
URC 6
=1 (PDU mode enabled):
Indicates that new SMS status report has been received
URC 7
=1 (text mode enabled):
Indicates that new SMS status report has been received
URC 8
+CDSI:
,
Indicates that new SMS status report has been received
Parameter Description
[0]
(&F)
Buffer unsolicited result codes in the TA. If TA result code buffer is full, indica-
tions can be buffered in some other place or the oldest indications may be dis-
carded and replaced with the new received indications.
1
Discard indication and reject new received message unsolicited result codes
when TA-TE link is reserved (e.g. in on-line data mode). Otherwise forward
them directly to the TE.
2
Buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g. in
on-line data mode) and flush them to the TE after reservation. Otherwise for-
ward them directly to the TE.
3
Forward unsolicited result codes directly to the TE. TA-TE link specific inband
technique used to embed result codes and data when TA is in on-line data
mode. Signaling of unsolicited result codes is configured by
Rules for storing received short messages depend on the relevant data coding method (refer to GSM 03.38),
preferred memory storage (
) setting and this value.
Note: If AT command interface is acting as the only display device, the ME must support storage of class 0 mes-
sages and messages in the message waiting indication group (discard message)
[0]
(&F)
No SMS-DELIVER indications are routed to the TE.
1
If SMS-DELIVER is stored in ME/TA, indication of the memory location is
routed to the TE using unsolicited result code:
(num)(&W)
(num)(&W)(&V)