At+cgqreq – Siemens Brodersen MC55 AT User Manual
Page 284
MC55_ATC_V04.00
Page 284 of 475
3/17/06
Confidential / Released
11.10
AT+CGQREQ Quality of Service Profile (Requested)
Syntax
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context. If no requested profile was explicitly
specified for a context, simply OK will be returned, but default values will be used for that context.
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate
PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter,
.
A special form of the set command, +CGQREQ=
causes the requested profile for context number
to become undefined.
will undefine the QoS profiles of every context which is not active or not online.
Parameter Description
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Precedence class
[0]
network subscribed value
1
High Priority
Service commitments shall be maintained ahead of precedence classes 2 and
3
Test Command
AT+CGQREQ=?
Response(s)
s), (list of
supported
s), (list of supported
s), (list of supported
s)
OK
Read Command
AT+CGQREQ?
Response(s)
[+CGQREQ:
,
,
[+CGQREQ: ...]
Write Command
AT+CGQREQ=
[
[,
[,
[,
]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s)
PIN
ASC0 ASC1
MUX1
MUX2
MUX3 Charge
Last
GSM 07.07
%
%
%
%
%
%
!
!
!
(num)
(num)