Class, Password, Mode – Siemens Brodersen MC55 AT User Manual
Page 111: Clck, Status
MC55_ATC_V04.00
Page 111 of 475
3/17/06
Confidential / Released
Supplementary Service Call Barring:
Supplementary Service "Call Barring" allows to specify conditions under which calls will be disallowed by the
network.
The availability of the Supplementary Services varies with the network. To benefit from call barring the client will
need to subscribe them, though a limited number of call barring types may be included in the basic tariff pack-
age.
When you attempt to set a
or
which is not provisioned, not yet subscribed to, or not sup-
ported by the module, the setting will not take effect regardless of the response returned. The responses in these
cases vary with the network (for example "OK", "+CME ERROR: Operation not allowed", "+CME ERROR: Oper-
ation not supported" etc.). To make sure check the extended error response with
and the lock status
with
: Network password supplied from the provider or operator. Usually there is one password which
applies to all call barring options. For details contact your provider.
"AO"
BAOC (Bar All Outgoing Calls)
"OI"
BOIC (Bar Outgoing International Calls)
"OX"
BOIC-exHC (Bar Outgoing International Calls except to Home Country)
"AI"
BAIC (Bar All Incoming Calls)
"IR"
BIC-Roam (Bar Incoming Calls when Roaming outside the home country)
"AB"
All Barring services (applicable only for
=0)
"AG"
All outGoing barring services (applicable only for
=0)
"AC"
All inComing barring services (applicable only for
=0)
0
unlock
1
lock
2
query status
0
lock is inactive
1
lock is active
Password string used to lock and to unlock a
. Length and authority for passwords depend on the
in question and are therefore listed in the section on parameter
. Passwords can be
modified with
Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-
vice or bearer service group as defined in "GSM 02.04".
1
voice
2
class 2 ("data") comprises all those individual data classes between 16 and
128, that are supported both by the network and the MS. This means, a setting
made for class 2 applies to all individual data classes (if supported). In addition,
you can assign a different setting to a specific class. For example, you can acti-
vate Call Forwarding for all data classes, but deactivate it for data class 64,
"dedicated packet access".
4
fax
8
SMS
16
data circuit sync
32
data circuit async
(num)
(num)
(str)
(num)