Siemens Brodersen MC55 AT - Manual (Page 412)

MC55_ATC_V04.00 Page 412 of 475 3/17/06
Confidential / Released
17.11 AT^SNFI Set microphone path parameters
AT^SNFI
controls the microphone path amplification. Read and write options of this command refer to the active
audio mode. The write command works only in audio modes 2 to 6.
Syntax
Parameter Description
ADC gain adjustable in eight 6 dB steps from 0 dB to 42 dB (0=0dB, 7=42dB, 8 steps of 6 dB).
0...7
Multiplication factor for input samples. Formula to calculate the negative gain (attenuation) of the input signal:
Gain in dB = 20 * log (inCalibrate / 32768)
0...32767
Notes
• The range of is up to 65535 but will be suppressed to 32767. Values above
brate>
= 65535 will cause a failure.
• The parameter of
AT^SNFI
is identical with of
AT^SNFA
.
• For use after restart, changed values can be stored with
AT^SNFW
.
• Attention! When you adjust audio parameters avoid exceeding the maximum allowed level. Bear in mind that
exposure to excessive levels of noise can cause physical damage to users!
Test Command
AT^SNFI=?
Response(s)
^SNFI:
(list of supported s) , (list of supported s)
OK
Read Command
AT^SNFI?
Response(s)
^SNFI:
,
OK
Write Command
AT^SNFI=
,
Response(s)
OK
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
SIEMENS ! % % % % % ! ! !
(num)(^SNFW)
(num)(^SNFW)