Siemens Brodersen MC55 AT - Manual (Page 240)

MC55_ATC_V04.00 Page 240 of 475 3/17/06
Confidential / Released
Syntax
Parameter Description
0 ... 9 specified with
AT^SISS
.
Internet service state.
Please note, that the state of an Internet service may influence the state of the serial DCD line. For details see
description of value 2 for parameter of command
AT&C
.
2 Allocated
Service profile resources are allocated, i.e. at least the service type has been
set (parameter , value "srvType" of
AT^SISS
). The service is
not opened, but ready for configuration.
3 Connecting
State after opening a service with
AT^SISO
where the connection is being
established.
If connection setup is successful the service proceeds to the state "4" (Up) and
one of the URCs "
^SISW
" and "
^SISR
" may follow. If connection setup is not
successful, the "
^SIS
" URC may appear and the service enters
6 (Down).
In the case of FTP, =3 means that the command channel is being
established.
If the service profile is configured as Socket listener, then the listener always
stays at =3 and =3 (LISTENER), while the
and of the dynamically assigned service pro-
file may change. See examples in Section 10.5.1 .
Test Command
AT^SISO=?
Response(s)
OK
Read Command
AT^SISO?
Response(s)
^SISO:
, value "srvType" [, , ,
, , , ]
[^SISO: ...]
OK
Write Command
AT^SISO=
Response(s)
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
§ % % % % % ! ! !
(num)
(num)