Siemens Brodersen MC55 AT - Manual (Page 422)

MC55_ATC_V04.00 Page 422 of 475 3/17/06
Confidential / Released
17.17 AT^SNFV Set loudspeaker volume
AT^SNFV
can be used to set the volume of the loudspeaker to the value addressed by
Step>
. The read and write commands refer to the active audio mode. The write command works only in audio
modes 2 to 6.
Syntax
Parameter Description
The actual volume of each step is defined by the parameter , which can be set with
AT^SNFO
.
0...4 (P)
Notes
• Any change to takes effect in audio modes 2 to 6. That is, when you change and
then select another mode with
AT^SNFS
, the same step will be applied. Nevertheless, the actual volume can
be quite different, depending on the values of set in each mode. The only exception is
audio mode 1 which is fixed to =4.
• is stored non-volatile when the ME is powered down with
AT^SMSO
or reset with
AT+CFUN
=1,1.
is not stored by
AT^SNFW
.
• can also be changed by
AT^SNFO
(Section 17.13 ) and
AT+CLVL
(Section 17.4 ).
Test Command
AT^SNFV=?
Response(s)
^SNFV:
(list of supported s)
OK
Read Command
AT^SNFV?
Response(s)
^SNFV:
OK
Write Command
AT^SNFV=
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
SIEMENS ! % % % % % ! ! !
(num)