Siemens Brodersen MC55 AT - Manual (Page 210)

MC55_ATC_V04.00 Page 210 of 475 3/17/06
Confidential / Released
9.10 AT+CLIR Calling line identification restriction
The
AT+CLIR
command refers to the GSM supplementary service CLIR (Calling Line Identification Restriction).
Syntax
Parameter Description
Parameter shows the settings for outgoing calls:
[0]
(P) Presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
Parameter shows the subscriber CLIR service status in the network:
0
CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Note
• The settings made with
AT+CLIR
=1 or
AT+CLIR
=2 are used for all outgoing calls until the ME is switched off
or
AT+CLIR
=0 is used.
Test Command
AT+CLIR=?
Response(s)
+CLIR:
(list of supported s)
OK
Read Command
AT+CLIR?
Response(s)
+CLIR
,
OK
ERROR
+CME ERROR:
Write Command
AT+CLIR=
[ ]
Response(s)
OK
ERROR
+CME ERROR:
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
GSM 07.07 % % % % % % ! ! !
(num)
(num)