Fujitsu Ricoh Fujitsu N7100E Network Image Scanner - Manual (Page 72)

4.2 Administrator Login
72
4.2.2 Administrator Login: via the Admin Tool
Using the Admin Tool allows the administrator to set up the scanner from a computer via
the network interface.
This section explains how to login using the Admin Tool.
When an administrator or user is already logged into a scanner, login via the Admin Tool
is not possible.
However, if automatic login is set, login via the Admin Tool is possible while the main
menu or job menu is displayed.
ATTENTION
 If the normal screen display does not appear (for example: an "X" mark appears), wait for a
few minutes and try again. If the problem still occurs, contact the distributor/dealer where you
purchased this product.
 If a button is rapidly pressed many times in succession, a "Communication error" message
may appear. In this case, wait for a few minutes and try again.
HINT
 For details about the system requirements to manage the scanner via a computer, refer to
"1.5.1 Requirements for Admin Tool and User Editor" (page 40) .
 If you do not perform any of the following operations for 20 minutes or more while the Admin
Tool is being used, the session times out.
 Button or tab operations on the menu
 Button operations on each setting window (except selecting items or inputting values)
Also, when [Secure initialize] is performed on the [System Settings File] window, the session
does not time out until the process is complete, because the [Secure initialize] process takes
longer than 20 minutes.
 The following are required for administrator login via the Admin Tool:
 "4.4.1 Setting the Scanner Name" (page 78)
 "4.6.4 Changing the Admin Password" (page 97)
 "4.7.1 Giving the Scanner an IP Address/DHCP" (page 99)
 "4.7.2 Setting the DNS Server" (page 101)
 "4.7.3 Setting the WINS Server" (page 102)
 "4.9.1 Setting the Admin Connection" (page 110)